QS212 Spoke Hub Motor(30H) 1000W V1 Type

QS212 Spoke Hub Motor(30H) 1000W V1 Type

Motor Specification:

1. Motor Type: BLDC Hub Motor with Permanent Magnets

2. Motor design: Double axle out spoke hub motor

3. Magnet Height: 30MM

4. Pole Pairs: 23 pairs

5. Rated Power: 1000W

6. Max Power: 1600W

7. Rated Voltage: 48V/60/72V

8. Speed: 30-50km/h(Can be customized)

9. Max No-load RPM: 650RPM Approx.

10. Max Torque: 80N.M

11. Max Efficiency: 87%

12. Rated current:24A

13. Max current:35A

14. Brake type: Disc brake or Drum brake(Optional)

15. Rear Fork width for installation: 200mm

16. Cross Section of Phase wire: 3 mm2

17. Axle thread:M12

18. Hall sensor phasing angle: 120 degree

19. Type of Sensor: Hall Sensor(3pcs)

20. Max. Working Temperature: 70 degree, Peak 120 degree

21. Cooling method:Air cooling

22. Waterproof Grade: IP67

23. N.W./ G..W. : 11kgs / 12kgs

Precautions for use

1. The motor is strictly forbidden to carry with it, and it is strictly prohibited to pull the lead of the motor.

2. When installing the tire, you must be careful, handle it lightly to avoid scratches or excessive force resulting in the motor hub, end cap, electric

Damage of crankshaft and lead wire.

3. All the phase wires and the terminals of the Hall element must ensure well connect, and there must be no looseness, otherwise the motor and controller may be burned. It is strictly forbidden to connect reversely or wrongly, otherwise it will cause permanent damage to the motor.

4. A controller that matches the motor or a controller recommended by the manufacturer must be used to ensure the reliability of the motor

5 It is forbidden to disassemble the motor, change the structure, refit, etc., otherwise the warranty will be invalid, and the unpredictable

Security incident!

6. The installation of the motor and the flat fork must be firm and reliable, and the fixing screws of the shaft must be tightened without any looseness.